Balluff BNI IOL-719-002-Z012 - Input signal range

www.balluff.com
9
3 Getting Started
Attention!
A care must be taken during wiring. The inputs are protected against wrong wiring,
but in some special cases damage can be occurred. Be sure to connect the wiring
properly before turning power supply on.
Note
Unused I/O port socked must be fitted with cover caps to ensure IP67
protection rating.
Note
The analog signals shall be connected with a shielded cable to the
BNI IOL-719-002-Z012
Note
In order to achieve better accuracy in case of thermocouple measurement, the
thermocouple should be connected to the device with a special M12 connector for
thermocouples (Typ J or Typ K, depending on the thermocouple.) .
1
2
3
4
PT100
BNI IOL-719-002-Z012
Sensor Interface
1
2
3
4
1
2
3
4
2-wire
3-wire
4-wire