Need help?Do you have a question about the Balluff Easy Tool-ID BSG TID-05-T30-00-005 and is the answer not in the manual?
General| Product Name | Balluff Easy Tool-ID BSG TID-05-T30-00-005 |
|---|---|
| Category | Network Hardware |
| Operating Frequency | 13.56 MHz |
| Housing Material | Plastic |
| Protection Class | IP67 |
| Connection | M12 Connector |
| Ambient Temperature | -25°C to +70°C |
| Operating Temperature | -25°C to +70°C |
This manual contains information for installing and operating the Balluff Easy Tool-ID system.
Details typographical conventions, symbols, and abbreviations used in the manual.
Guides users to related manuals and lists requirements for third-party software like .NET and PDF readers.
Lists all versions of the manual with their release dates and descriptions of changes.
Explains how tool data is stored on an RFID data carrier embedded in the tool holder.
Describes the Easy Tool-ID system as a tool stand with RFID, microcontroller, and USB connectivity.
Details how to install the stand, anchor it, and connect it to the HMI, including USB cable caution.
Covers safety precautions for installation, operation, and use, including warnings about unauthorized intervention and environmental conditions.
Provides steps to resolve issues like system not responding or incorrect data output.
Lists the necessary system requirements for installing and running the configuration software.
Step-by-step guide on creating a new configuration plan, including naming and assigning tool type numbers.
Guide to adding shortcut steps, including key combinations and delays, for automating sequences.
Instructions on how to send the configuration data to the Easy Tool-ID hardware.
Steps to update the firmware of the Easy Tool-ID device if a red X is shown for FW status.
To Next Page
