BSG TID-05-T30-01-005
27
5 The Configuration Software
5.14. Special Function "Decimal Places"
The Easy Tool-ID System outputs three decimal places by default. Some machines only ac-
cept less than three decimal places. You can change the amount of decimal places in the
software.
• Select a data field with decimal places. E.g.: the "Cross Dimension (X)" data field. (1, 2,
3)
• Select the amount of decimal places in the "Decimal Places" field. (Values from 1 to 3
are allowed). (4)
• Confirm your entry by clicking "Add". (5)
Figure 20: Selecting the "Convert to diameter" function
To Next Page
Loading...