4 Manual Documentation Number M3640D1598
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 433-5104
3. PREPARING FOR OPERATION
3-1. Installing the Battery
Your meter requires a 9V battery for power. The symbol appears
when the battery voltage drops to certain limits. For proper operation,
replace the battery as soon as possible. Continued use with a low battery
will lead to abnormal readings.
WARNING: TO AVOID ELECTRIC SHOCK, DISCONNECT BOTH
LEADS FROM EQUIPMENT BEFORE YOU REMOVE OR INSTALL
THE BATTERY.
Follow these steps to install the battery:
1. Turn off the power and disconnect the two test probes.
2. Remove the screw to open the battery compartment.
3. Place the battery into the insulation capsule and snap it on the
contacts.
WARNING: DO NOT DISCARD THE PROVIDED BATTERY
INSULATION CAPSULE. IF YOU DO NOT USE THIS
INSULATION CAPSULE PROPERLY, IT MIGHT CAUSE
DAMAGE OR INJURY.
4. Replace the battery compartment cover and secure it with the screw.
WARNING: DO NOT OPERATE THE METER UNTIL YOU
REPLACE THE BATTERY AND CLOSE THE BATTERY
COMPARTMENT COVER.
To Next Page
Loading...