B&G LCD Plotter
Part 2 - Operating Information
HB-0847-02
2-12
2.11.2 Route Present in Cursor Mode
• Range, from the boat position to the cursor
• Time enroute (true boat speed)
• Bearing
• Cursor position
• Chart range
2.11.3 Waypoint Editing
If the cursor is placed over a waypoint, a window will appear prompting you
to either delete the waypoint or move it. Press the ENTER key to move it, or
press the CLEAR key to delete it.
By pressing the ENTER key, to move a waypoint, this window will display
the following information:
• Cursor position (the position will change until the waypoint is fixed by
ENTER)
• Chart range
When the cursor is placed on a segment of the route, a window is displayed
showing the two waypoints placed at the extremities of the segment; by
pressing the ENTER key, it is possible to insert a new waypoint. After a
waypoint is inserted, this window gives the co-ordinates relative to the new
waypoint.
2.11.4 Navaids Window
If the cursor is moved over a navaid, a window will be displayed showing:
• The Latitude/Longitude of the selected navaid
• The characteristics for the navaid
To Next Page
Loading...
