B&K Reference 30 - Rear Panel Connections: Audio and Video; Analog and Digital Audio;Video Inputs; Output Connectors and Fuse Holder

12. Component Video inputs - Switched input connections for two component video devices.
12. Component Video inputs - Switched input connections for two component video devices.
Red RCA jack
- typically connect to the red output of a component video source
Green RCA jack
- typically connect to the green output of a component video source
Blue RCA jack
- typically connect to the blue output of a component video source
13. Line inputs - Connections from your audio/video sources.
Red RCA jacks
- right analog audio
White RCA jacks
- left analog audio
Yellow RCA jacks
- composite video
4 pin din jacks
- S-video
14. Line level outputs - Fixed level outputs to an audio or video recorder.
15. Zone 2 (B) outputs - Variable level outputs to your video monitors and external amplifiers.
16. Zone 1 (A) outputs - Variable level outputs to your video monitors.
17. Optical Digital inputs - Optical digital inputs are used to connect digital audio signals from your source to the
processor. The incoming signal may be PCM, Dolby Digital or DTS.
18. Optical Digital output - Zone 1 (A) optical output to carry digital information from the selected digital input of
the processor out to digital recorders, personal computers, etc.
19. Coax Digital inputs - Coax digital inputs are used to connect digital audio signals from your source to the
processor. The incoming signal may be PCM, Dolby Digital (AC-3) or DTS.
20. Coax Digital output - Independent Zone 1 (A), and Zone 2 (B), coax outputs to carry digital information from
the selected digital input of the processor out to digital recorders, personal computers, etc.
21. AC fuse holder - Holds the AC Line fuse. Replace only with same type and value.
12
p/n 12857 Rev. 0717A