B&K Reference 30 - DSP Usage Information; RS-232 Control Port Setup; RS-232 Port Configuration

DSP Usage
Allows displaying the current DSP usage in MIPS.
ADVANCED SYSTEM SETUP
1 Zone 1 Setu
p
'A'
2 Zone 2 Setu
p
'B'
3 Power On Titles
4 Control Out
5 Securit
y
O
p
tions
6 DSP Usa
g
e
7 RS-232 Control Port
next item SEL select
MENU setu
p
s
y
stem
6 DSP Usa
g
e
DSP USAGE
1 Utilized DSP
Processin
g
Power
XXX MIPS
MENU advanced setu
p
1 Utilized DSP
Processin
g
Power
XXX MIPS
'63 86$*(
;;; 0,36 )5((
display currently used DSP MIPS
∧ (UP) or ∨ (DOWN)
 (PAUSE) or  (STOP)
3
activate DSP USAGE
↵ (ENTER)
SEL or ENTER2
move to DSP Usage
∧ (UP) or ∨ (DOWN)
 (PAUSE) or  (STOP)
1
ActionFrom Front PanelFrom Remote
RS-232 Control Port
Configure the advanced computer interface control port on your processor. For further information concerning
RS-232 operation, see BKC-DIP for the computer interface protocol, and the AVR307 and Reference 30 device
specific appendix's.
RS-232 port setup -
ADVANCED SYSTEM SETUP
1 Zone 1 Setu
p
'A'
2 Zone 2 Setu
p
'B'
3 Power On Titles
4 Control Out
5 Securit
y
O
p
tions
6 DSP Usa
g
e
7 RS-232 Control Port
next item SEL select
MENU setu
p
s
y
stem
7 RS-232 Control Port
RS-232 PORT SETUP
1 Port Enable
2 Baud Rate 9600
3 Echo Enable
4 U
p
date Enable
5 Receive ID 0
6 Transmit ID 0
next item SEL select
MENU advanced setu
p
1 Port Enable
56 3257
3257 (1$%/('
select Enabled or DisabledVOLUME KNOB

(REW) or

(FF)
4
move to Port
∧ (UP) or ∨ (DOWN)
 (PAUSE) or  (STOP)
3
activate RS-232 PORT SETUP
↵ (ENTER)
SEL or ENTER2
move to RS-232 Control Port
∧ (UP) or ∨ (DOWN)
 (PAUSE) or  (STOP)
1
ActionFrom Front PanelFrom Remote
73
p/n 12857 Rev. 0717A