ADJUSTING THE VOLUME
= 92/80(
Z1 Master Volume 0.0 dB
instant volume all the way down
press MUTE again to restore
can’t do from front panel
MUTE
adjust volumeVOLUME KNOB
VOLUME ∧ or VOLUME ∨
ActionFrom Front PanelFrom Remote
Note: The front panel VOLUME KNOB is used to control multiple functions and, therefore, cannot always control
the volume. The VOLUME KNOB may control volume in the menu system when not used for parameter
adjustments. During normal operation the VOLUME KNOB may switch to controlling other functions but will return
to MASTER LEVEL after a few seconds. The remote’s VOLUME ∧ or VOLUME ∨ will always change master
volume level except in the SETUP SPEAKER LEVELS and SETUP ‘Source’ INPUT menus.
TEMPORARY LEVEL ADJUSTMENTS
Occasionally you may find that a you can’t hear the dialog very well in a particular movie, or a movie has too much
bass, etc. You can temporarily adjust the center, surround, and subwoofer settings without changing the
permanent settings you made in the under SETUP SPEAKER LEVELS menu.
= &(17(5
Z1 Center Volume 0.0 dB
adjust subwoofer volumesee Zone 1 (A) operation
SUB
or SUB
adjust surround volumesee Zone 1 (A) operation
REAR
or REAR
adjust center volumesee Zone 1 (A) operation
CENTER
or CENTER
ActionFrom Front PanelFrom Remote
Note: these settings are temporary and will be lost when you put your processor to sleep or turn off the main
power. If you have particular temporary setting that you use often, you may save them in a preset.
48
p/n 12857 Rev. 0717A
To Next Page
Loading...
Need help?
General
