B&K Reference 30 - Display Settings: Zone 1 Aspect Ratio; Zone 1 Monitor Aspect Ratio Setup

SETUP DISPLAYS
1 Front Panel Bright
2 Overlay Opaque Bright
3 Backround Color Blue
4 Z1 Monitor Video Manual
5 Z1 Monitor Aspect 4 : 3
next item adjust
MENU setup system
9,'(2 0$18$/
4 Z1 Monitor Video Manual
adjust for desired operationVOLUME KNOB

(REW) or

(FF)
2
move to Zone 1 (A) Video Monitor
∧ (UP) or ∨ (DOWN)
 (PAUSE) or  (STOP)
1
ActionFrom Front PanelFrom Remote
Set the Zone 1 (A) Monitor Aspect Ratio -
During normal operation, your processor will overlay status
information on your video monitor. This information is normally displayed at the bottom of the monitor. However,
if you are viewing letterbox material on a 16:9 (widescreen) monitor, this information will be cut off. Selecting the
16:9 monitor aspect ratio will position the status display within the letterbox viewing area. This setting does NOT
affect setup menus. Your monitor must be set for normal 4:3 viewing in order to display the entire menu page.
SETUP DISPLAYS
1 Front Panel Bright
2 Overlay Opaque Bright
3 Backround Color Blue
4 Z1 Monitor Video Manual
5 Z1 Monitor Aspect 4 : 3
next item adjust
MENU setup system
$63(&7 
5 Z1 Monitor Aspect 4 : 3
return to SETUP SYSTEM
∠ MENU
MENU3
change aspect ratioVOLUME KNOB

(REW) or

(FF)
2
move to Zone 1 (A) Monitor Aspect
∧ (UP) or ∨ (DOWN)
 (PAUSE) or  (STOP)
1
ActionFrom Front PanelFrom Remote
38
p/n 12857 Rev. 0717A