Setup Mode
Access Setup mode and the sensor menu from Run mode by pressing and holding MODE for longer than 2 seconds. Use and to navigate
through the menu. Press SELECT to select a menu option and access the submenus. Use
and to navigate through the submenus. Press
SELECT to select a submenu option and return to the top menu, or press and hold SELECT for longer than 2 seconds to select a submenu option
and return immediately to Run mode.
To exit Setup mode and return to Run mode, navigate to
and press SELECT.
Note: The number that follows a menu option, for example , indicates the channel that is selected. For menu items
without a number (excluding submenu items), these menu options are only available from Channel 1 and the settings apply to
both channels.
Q4X Stainless Steel Laser Sensor with Dual Discrete Outputs and IO-Link
4 www.bannerengineering.com - Tel: + 1 888 373 6767 P/N 190073 Rev. G
To Next Page
Loading...
