2. Check for sources of electrical noise.
a)
Turn off the Scanner.
b) Cover the lens of the BT-1 with electrical tape to block optical light from getting into the receiver lens.
c) Press the RCV button on the BT-1 and position the Beam Tracker on the wires going to the Scanner or any other
nearby wires.
d) To reduce or eliminate noise caused by the switching of inductive loads, install proper transient suppression
across the load.
3. Try using a separate filtered power supply and/or a grounded shielded cable to connect the scanner to the cabinet to
eliminate external causes of the nuisance noise.
SX Safety Laser Scanner
www.bannerengineering.com - Tel: + 1 888 373 6767 113
To Next Page
Loading...
