4.
Gently disconnect the removable memory device by lifting it from the scanner.
5. Connect the machine interface cable(s) (8-pin or 12-pin or 17-pin or 17- and 8-pin, depending on model).
6. Insert the removable memory device back onto the connector of the scanner and tighten the two screws (tightening
torque is 1 N·m).
7.
Replace the protective cover and tighten the two screws to hold it in place (tightening torque is 0.5 N·m).
SX Safety Laser Scanner
46 www.bannerengineering.com - Tel: + 1 888 373 6767
To Next Page
Loading...
