aAORENO
www.baofengradio.us http://www.baofengradio.us
www.foscam.us
Menu Definitions
Menu Item Shortcut Description
AUTOLK 24
AUTOmatic Keypad LocK: When ON, the keypad will be
locked if not used in 8 sees. Pressing the [POUND] button for
2 seconds will temporarily unlock the keypad.
Availability: Global
Settings/Notes
Note: When the keypad is locked, a 'ttO' symbol is indicated in the stams display
Note: The keypad lock only locks the buttons on the front face of the BF-F9V2+. It does
not lock the [CALL] button, the [PTT] button or the [MONI] button.
Menu Item Shortcut
Description
T-CTCS 25
Frequency ShiFT— Direction: Enables access of repeaters in
VFO/Frequency Mode.
Availability: VFO/Frequency Mode, Stored in Channe
Settings/Notes
OFF[0] | + [1] | - [2] Default: OFF
OFF: TX = RX (simplex)
+: TX will be shifted higher in frequency than RX
-: TX will be shifted lower in frequency than RX
Note: When SFT-D is set to +, a '+' is indicated in the status display (VFO/Frequency
mode only)
Note: When SFT-D is set to -, a '-' is indicated in the status display (VFO/Frequency
mode only)
Note: Used with menu 26 to access repeaters in VFO/Frequency mode (+ and - only)
Note: SFT-D is not required when storing repeater frequencies into channels
55
aAOF=ENE
www.baofengradio.us http://www.baofengradio.us
www.foscam.us
Getting to Know the Radio
Battery Level Indicator
When the battery level indicator has no black bars showing, it means the battery is
close to depletion. To warn the user of this, the radio will start beeping periodically
as well as flashing the backlight of the display, indicating that the battery needs to
be changed.
Status LED
The status LED has a very simple and traditional design. When a signal is received,
it turns green, when transmitting, it turns red, and is off when in standby.
Side Button 1- Call (Broadcast FM and alarm)
Press [CALL] momentarily to start the broadcast FM receiver. Another momentary
press turns the broadcast FM receiver off.
Press and hold to [CALL] activate the alarm function. Press again to turn it off.
Side Button 2-MONI (Monitor and Flashlight)
Press [MONI] momentarily to turn on the LED flashlight. Another momentary press
turns the flashlight off.
Press and hold [MONI] to monitor the signal. This will open up the squelch and permit
listening to the unfiltered signal.
VFO / MR- Mode Button
Pressing [VF0/MR] switches between Frequency (VFO) Mode and Memory (MR)
Mode. Memory mode is sometimes also referred to as Channel mode.
To save frequencies to channel memory the radio must be in Frequency (VFO) mode.
A/B-Select Button
The [A/B] button switches between A (upper) and B (lower) displays. The frequency
or channel on the selected display becomes the active listening and transmit frequency
or channel.
Note: To save frequencies to channel memory the radio must be set to use the A
display.
16
To Next Page
Loading...
