Baofeng BF-F9V2+ - Basic Use; Power and Volume Control

aAORENE
www.baofengradio.us http://www.baofengradio.us
www.foscam.us
Basic Use
Power and Volume
Before the power is turned on, ensure that the battery and antenna are both attached,
as described in the Initial Setup section.
Turning the Unit On
To turn the unit on, rotate the volume/power knob clockwise until a "click" sound is
heard. If the radio powers on correctly, there should be an audible double beep, and
the display and backlight should turn on, looking something like picture below:
■EL
.*■*. : :." s
■...■ W •...'
m ■■■■« ■■■
■■ ■ ■ m
m * ■■■■ ■ ■■
■ » ■ ■ ■ *
■■■■■ ■ ■■ m
.. fl mmm *BMB"
Turning the Unit Off
Turn the volume/power knob counter-clock wise all the way until a "click"sound is
heard. The unit is now off.
Adjusting the Volume
To turn up the volume, turn the volume/power knob clock-wise.
To turn the volume down, turn the volume/power knob counter-clock-wise. Be careful
not to turn the knob too far, as you may accidentally turn the radio off.
A good way to adjust volume is by using the monitor function, enabled from the
[MONI] button below the [PTT] button, to more accurately and easily adjust the
volume by adjusting it to the un-squelched static sound.
aAOFENG
www.baofengradio.us
http://www.baofengradio.us
www.foscam.us
Menu Definitions
Menu Item
SC-REV
Shortcut
Description
SCan-REVive/Resume Method: TO [0] | CO [1] | SE [2]
Default: TO
Availability: Global
Settings/Notes
TO: Time Operation - scanning will resume after a fixed time has passed.
CO: Carrier Operation - scanning will resume after the active signal disappears.
SE: Search Operation - scanning will not resume.
Menu Item
PTT-ID
Shortcut
19
Description
When to Send PTT-ID
Availability: MR/Channel Mode (Read Only), VFO/Frequency Mode, Stored in Channel
Settings/Notes
OFF [0] | BOT [1] | EOT [2] | BOTH [3] Default: OFF
OFF: No ID is sent.
BOT: The selected S-CODE is sent at the Beginning of Transmission.
EOT: The selected S-CODE is sent at the End of Transmission.
BOTH: The selected S-CODE is sent at the BOT and the EOT.
Note: Select S-CODE using menu 17.
Note: Recommended setting is OFF.
19
52