Baofeng BF-F9V2+ - Tone Scanning Procedure

aAOF=ENI3
www.baofengradio.us
http://www.baofengradio.us
www.foscam.us
Menu Definitions
Menu Item Shortcut
Description
BEEP 8
Keypad BEEP: Allows audible confirmation of a button press.
Availability: Global
Settings/Notes
OFF [0] | ON [1] Default: ON
Menu Item Shortcut
Description
TOT
Transmission Time-Out Timer: This feature provides a safety
switch which limits transmission time to a programmed value.
This will enable battery conservation by preventing excessively-
long transmissions, and in the event of a stuck PTT button
(possibly due to a radio becoming wedges between two things),
it can prevent interference to other users and excessive battery
depletion.
Availability: MR/Channel Mode (Read Only), VFO/Frequency Mode, Separate VFO
A & B Settings, Stored in Channel
Settings/Notes
15 [0] - 600 [39] in 15 second steps (see TOT Table) Default: 60
Note: The red TX LED begins to flash 10 seconds before the timeout limit is reached.
Note: (TIMEOUT-15)/15=[n]
47
aAOF=ENI3
www.baofengradio.us
http://www.baofengradio.us
www.foscam.us
Scanning
Tone Sc an ni ng
You can scan for CTCSS tones and DCS codes on active frequencies in frequency
mode.
To scan for CTCSS or DCS on active channels, follow these steps:
Procedure: Tone Scanning
1. Press the [MENU] button to enter the menu.
2. Enter either of the following on the numeric keypad.
a. Enter [1] [0] on the numeric keypad to scan for DCS codes.
b. Enter [1] [1] on the numeric keypad to scan for CTCSS sub-tones.
3. Press the [MENU] button to select.
4. Press the [SCAN] button momentarily.
5. CT or DCS will start flashing in the display as the radio starts scanning. Once
it finds a tone or code in use, it will beep and stop flashing, indicating that a
tone or code has been found.
6. Press the [SCAN] button to confirm.
7. Press the [EXIT] button to exit the menu.
24