ON
When ON, the keypad will be locked if not used in 8 seconds. Pressing the
key for 2 seconds will unlock the keypad.
17 Alarm Mode
On Site Sounds alarm through your radio speaker only
Transmits a cycling tone over-the-air
Transmits '119' (911 in reverse) followed by the ANI code over-the-air
18 Alarm Tone
The radio speaker blocks the alarm sound.
The radio speaker sounds an alarm
View the ANI ID, and if necessary, will allow to change the ANI ID
20 DTMF-ST
No DTMF Side Tones are heard
Side Tones are heard only from manually keyed DTMF codes
Side Tones are heard only from automatically keyed DTMF codes
DT+ANI All DTMF Side Tones are heard
21 PTT-ID
The selected S-CODE is sent at the beginning
EOT The selected S-CODE is sent at the ending
The selected S-CODE is sent at the beginning and ending
Signal code sending delay. PTT-ID Delay (milliseconds)
23 ALERT
1000Hz
The following configurations will transmit accordingly:
PTT + SK1= Transmits 1000Hz Tone Burst
PTT + SK1= Transmits 1450Hz Tone Burst
1750Hz
+ SK1= Transmits 1750Hz Tone Burst
PTT + SK1= Transmits 2100Hz Tone Burst
24 TAIL
Disable Squelch Tail Elimination.
ON
Enable Squelch tail elimination. to prevent any squelch tails from being
25 Press SK2