Baofeng UV-25 Plus - Page 39

VOX
VOX on/off
26 Reset
VFO
Reset the radio's VFO menu to factory defaults (no reset for bank, scan
settings)
ALL Resets the radio to factory defaults, with some exceptions.
4 GNSS
1 GPS On/Off
OFF
Turn off the position system, long press the MENU key is ineffective
ON
Turn on the position system, press and hold the MENU key to enter GPS
mode
2
Time Zone
-12 to 0 to + 12
Set the time zone of the region
3 GPS Mode
GPS
BDS
GPS+BDS
5
Program
Channel
1 CH.NAME Channel 1
View channel name, allows to rename the current channel. Press the
key to switch the input method, allowing the input of letters, numbers and
symbols.
2 RX Frequency
View the current channel Receiver frequency, allow to change the current
frequency. Input the RX frequency by keypad, click the Menu key to save
3 TX Frequency
View the current channel Transmitter frequency, allow to change the
current frequency. Input the TX frequency by keypad, click the Menu key to
save
4 Trans Power
High Selects between HIGH transmitter power when in VFO/Frequency mode.
Mid Selects between Middle transmitter power when in VFO/Frequency mode.
Low Selects between LOW transmitter power when in VFO/Frequency mode.
5 Bandwidth
Wide
Wideband (25 kHz bandwidth)
Narrow
narrowband (12.5 kHz bandwidth)
6 RX CTCSS OFF;67-254.1
Mutes the speaker of the transceiver in the absence of a specific and
continuous sub-audible signal. If the station you are listening to does not
transmit this specific and continuous signal, you will not hear anything.