Baofeng UV-3R+ - Page 16

ie BAOFENG
downward (-) or upward (+). One of these icons
will appear at the top of the LCD when repeater
shifts have been enabled.
1)Press [ MENU/LOCK ] , rotate the [DIAL ]
knob, come to MENU [11]: SHIFT
2)Then press [ U/V ] key to enter the set mode.
3)Clockwise or counterclockwise rotation of
{ DIAL } knob to select the repeater shifts: 0/-/+
4)Press [ U/V ] key to save the setting.
5)Press [ MENU/LOCK ] or [PTT] , EXIT to
normal operation.
STE (Tail Tone Elimination)
To eliminate the annoying audio caused by carrier
wave disappearing after the transmitter ends the
communication. You should enable the Tail Tone
Elimination. On the contrary, if you want
communication via the repeater, you should disable
the Tail Tone Elimination.
1)Press [ MENU/LOCK ] , rotate the [ DIAL ]
knob, come to MENU [12]: STE
2)Then press [ U/V ] key to enter the set mode.
3)Clockwise or counterclockwise rotation of
[ DIAL } knob to select the STE: ON/OFF
4)Press [ U/V ] key to save the setting.
5)Press [ MENU/LOCK ] or [PTT] , EXIT to
normal operation.
24
4 ‘N
BAOFENG
WIN (Wide/Narrow Band Selection)
1)Press [ MENU/LOCK ] , rotate the [DIAL ]
knob, come to MENU [13]: W/N
2)Then press [ U/V ] key to enter the set mode.
3)Clockwise or counterclockwise rotation of
{ DIAL ] knob to select the WIDE/NARROW:
4)Press [ U/V ] key to save the setting.
5)Press [ MENU/LOCK ] or [PTT] , EXIT to
normal operation.
SAVE (Battery Saver)
The UV-3R includes a useful Transmit Battery
Saver, which will automatically lower the power
output level when the last signal received was
very strong. For example, when you are in the
immediate vicinity of a repeater station, there
generally is no reason to use the high power output
in order to achieve full quieting access to the
repeater. With the transmit battery saver, the
automatic selection of Low Power operation
conserves battery drain significantly.
To activate the Transmit Battery Saver:
1)Press [MENU/LOCK ] , rotate the [ DIAL }
knob, come to MENU [14]: SAVE
2)Then press {uv ] key to enter the set mode.
25
7 ‘N