3. Getting started
3. GETTING STARTED
Overview
• Activating the bas e unit
•BasicUse
• User Interface
• Capture more
• Shared desktop: primary - extended
•Audioconfiguration
• Pairing
3.1 Activating the base unit
About power mode
The Base Un it is powered via an ex ternal power adapter. Once connected, the B ase Unit is automatically switched in standby mode.
For more information about power connection, see CSE-200’s installation manual.
On and off
1. Push the button s hortly.
Image 3-1
Standby button
When the Base U n it was on, it goes out
When the Base Unit was off, it starts up.
3.2 Basic Use
Basic functionality
When entering a meeting room equipped
with ClickShare and if the display is not in screensaver mode, the ClickShare wallpaper is
shown on the display. The content of the wallpaper depends on the setup.
Starting to use ClickShare is no w very simple.
To start using ClickShare
1. Take a Button and Insert the Button into a USB port of your laptop.
R5900025 CSE-200 16/02/2016
9
To Next Page
Loading...
Need help?
General
