Barco LCD 5521 V4 User Manual

5. Mechanical setup of display wall with pedestals
Pedestal
65
The front access mount comes pre-installed for
OVD/KVD/IVD. However it is recommended to
use the jig and check the distance!
Use the jig R872756.
Apply the jig on the front side of the front access
mount module.
In case of OVD/
KVD/IVD: make sure that the jig is
used showing imprint KVD on top!
Pedestal
66
The front access mount comes pre-installed for
OVD/KVD/IVD.
For HVD, you need to re-position the horizontal
profile.
Use the jig R872756.
Apply the jig on the front side of the front access
mount module.
In case of HVD: make sure that the jig is used
showing imprint HVD on top!
Pedestal
67
Shift the jig to the left and the right side of the
horizontal profile.
(Every front access module comes with one jig.
Since the jig is only required for rows >=2 you can
use also the jig of the front access modules in-
stalled in row = 1.)
On the left and on the right, use 1x B361304 SCR
ASS D188K M8X25 STZN and fix the jig on the top
horizontal profile of the row below!
Barco - LCD 5521 V4 - R591734 - Installation manual - Revision 00 - March-2017
_____________________________________________________________
55

Barco LCD 5521 V4 Specifications

General

Brand	Barco
Model	LCD 5521 V4
Category	Monitor
Language	English