3. Display installation
To connect the signal cables to the display:
You may connect the display to a display controller by using the DVI or the DP connection. The active
input can be selected in the OSD menu.
1. Connect the DVI or DP of the display controller to the DVI or DP connector of the display.
2. If you want to make use of the display’s USB downstream connectors, connect a PC USB downstream
connector to the display’s USB upstream connector.
3. If you have chosen to use the display’s USB downstream connectors, connect a USB device to one of
the downstream connectors.
4. Connect the supplied external DC power supply to the +24 VDC power input of the display.
14
B4100592 CORONIS 5MP 05/08/2014
To Next Page
Loading...
