3. Display installation
5. Plug the mains connector of the external DC power supply to a grounded power outlet by means of
the supplied power cable.
3.5 Routin g the cables
To route the cables
1. Route the cables alongside the neck and in the cable ducts in the
tilt & swivel foot.
2. Re-attach the connector compartment cover and neck cover. Close the cable duct covers. Push the
cable duct covers upwards to lock them.
To route the cables on a dual foot
If the display is mounted o
n the system dual tilt & swivel foot, cables are best routed behind the arms and
through the cable channel in the foot shaft, as shown in the pictures below .
B4100592 CORONIS 5MP 05/08/2014
15
To Next Page
Loading...
