3. Display installation
Note: When both displays are not correctly aligned, minor corrections are possible in relative height
and relative angle, by loosening and tightening the opposite pairs of allen screws (opposite sides
or opposite diagonals) of the positioning sliders.
3.2 VESA-mount installation
The display mounting anchor is compatible with the VESA 100 mm standard.
WARNING: N ever move a d isplay attached to an arm by pulling or pushing the display
itself. Instead, make sure that the arm is equipped with a VESA approved handle and
use t his to move the display.
Please refer to the instruction manual of the arm for more information and instructions.
WARNING: Use an arm that is approved by VESA (according to the VESA 100 mm stan-
dard).
Use an arm that can support the weight of the display. Refer to the technical specifica-
tions of this display for the appl
icable weight.
Overview
The display mounting anchor is compatible with the VESA 100 mm standard.
1. Unscrew the four fixation screws in the mounting anchor.
B4100592 CORONIS 5MP 05/08/2014
11
To Next Page
Loading...
