4. Daily operation
In case of a power outage recovery, your display will always start-up in the power mode
it was in before the power interruption (i.e. standby or on). This protects your display
against inadvertent image retention problems.
4.4 Bringi ng up the OSD menus
How to bring up the OSD menus
TheOSDmenuallowsyoutoconfigure different settings to make your Coronis 5MP fit your needs within
your working environment. Also, you can retrieve general information about your display and its current
configuration settings through the OSD menu.
Bringing up the OSD menus can be done by:
1. If not already done so, switch on the display as previously described.
2. Illuminate the keys as previously described.
3. While the keys are illuminated, touch the menu key.
As a result, the OSD main menu comes up in the center of the screen. However, if no further actions are
taken within the following 90 seconds, the OSD will disappear again.
The OSD menu auto-exit function can be disabled in the OSD menu. Please refer to
"OSD menu automatic close function", page 21 for detailed instructions on how to do
this.
The OSD menu position can be modified in the OSD menu. Please refer to "OSD menu
position", page 21 for detailed instructions on how to do this.
4.5 Navigating th rough the OSD menus
How to navigate through the OSD menus
Navigating through the OSD menus can be done by:
• Use the up/down keys to move through the (sub)menus, change values or make selections.
• To go into a submenu or confirm adjustments and selections, use the menu key.
• Us the standby key to cancel adjustments or exit a (sub)menu.
• Exit all OSD menus at once by touching the standby key for approximately 2 seconds.
B4100592 CORONIS 5MP 05/08/2014
19
To Next Page
Loading...
