3. Display installation
1
2
2
Removal of the cable cover of a dual foot
To get access to the cable routing channel of a dual foot, the display stand cable cover should be removed.
To remove this cover, proceed as follows:
1. Gently press and hold the lock clips at the inside of the top of the cover.
2. Slide the cover upwards on the shaft while holding the clips pressed.
It may be needed to tilt the displays if the arm is blocking the movement of the cover.
1
2
3.4 Conn ecting the sign al cables
CAUTION: Only connect one of the two video links. Connecting both inputs simultane-
ously will result in driver errors.
B4100592 CORONIS 5MP 05/08/2014 13
To Next Page
Loading...
