5. Advanced operation
To enable/disable hibernation on your display:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Power Management menu.
3. Enter the Hibernate submenu.
4. Select Enabled/Disabled as desired and confirm.
To specify the hibernate timeout:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Power Management menu.
3. Enter the Hibernate Timeout submenu.
4. Set the timeout value as desired and confirm.
5.12 Lumin ance target
About the luminance target
The luminance target of your Coronis 5MP is adjustable over a predefined range. When you change the
luminance target, the display will adjust its backlight to reach the target.
To set the luminance target:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Calibration menu.
3. Enter the Luminance Target submenu.
4. Set a luminance target value as desired and confirm.
The default, factory DICOM calibrated luminance value is available in t he technical spec-
ifications table. The guaranteed backlight lifetime is valid for this se tting.
5.13 Viewing mo des
About viewing modes
The Coronis 5MP can be used in two viewing modes:
Diagnostic
This mode provides the full calibrated luminance
and is intended for using the display for diagnostic
purposes.
Text In this mode, t he luminance is reduced to
approximately half of the luminance. This
is intended for using the display with office
applications such as word processing.
Please note that text mode is not persistent, once
powered off, the unit will restart in diagnostic mode.
B4100592 CORONIS 5MP 05/08/2014 25
To Next Page
Loading...
