3. Display installation
3.6 F irst time starting up
Overview
You are now ready to start up your Coronis 5MP for the first time.
1. Switch on your Coronis 5MP as described in "Standby switching", page 18.
2. Turn on the computer connected to your display.
If you have properly installed your display and display controller, the Windows start-up messages will
appear once the boot procedure is finished.
Your Coronis 5MP will be running in a basic video mode at a default refresh rate when
first time starting up. If you are using a Barco d ispla y controller, please consult the user
guide delivered with it to inst
all the drivers, software and documentation. When this
is done, your displa y will automatically detect the connected video i nput signal(s) and
apply the correct video mode and refresh rate.
16 B4100592 CORONIS 5MP 05/08/2014
To Next Page
Loading...
