Preface
11
Water and moisture
The display is IPx1 compliant.
Note: The power supply is not approved for IPx2. The power
supply must be mounted in a flat position for best resistance to
fluids.
Ventilation
Heed the necessary free space around the display to allow enough air
flow for cooling of the display.
Installation
Place the display on a flat, solid and stable surface that can support the
weight of at least 3 displays. If you use an unstable cart or stand, the
display may fall, causing serious injury to a child or adult, and serious
damage to the equipment.
Do not allow to climb or rest on the display.
When adjusting the angle of the display, move it slowly so as to prevent
the display from moving or slipping off from its stand.
When display is attached to an arm, do not use the display as a handle
or grip in order to move the display. Please refer to the instruction
manual of the arm for instructions on how to move the arm with the
display.
Provide full attention to safety during installation, periodic maintenance
and examination of this product.
Sufficient expertise is required for installing this product, especially to
determine the strength of the wall for withstanding the display’s
weight. Be sure to entrust the attachment of this product to the wall to
licensed contractors of Barco and pay adequate attention to safety
during the installation and usage.
Barco is not liable for any damage or injury caused by mishandling or
improper installation.
More warnings in the Installation chapter.
To Next Page
Loading...
Need help?
Display Specifications
