Barco Nio E-2621 - Page 52

Installing drivers and software
52 Nio display systems
• Windows Server 2003 x64 Edition.
You will need to install the Nio display system drivers and software in
the following cases:
• After you have installed the display controller(s) for your B
ARCO
N
IO Display System in your system for the first time.
• After you have reinstalled or upgraded your operating system.
1. Start your system. When the Found New Hardware Wizard comes
up, click Cancel. When the System Settings Change window asks
you to restart your computer, click No.
2. Run the Barco Product Installation Wizard.
The Barco Product Installation Wizard should start automatically if
you insert the B
ARCO NIODisplay System Installation CD-ROM into
your CD drive after the operating system has started. If your CD
drive’s auto-run is not enabled or the Barco Product Installation
Wizard does not start automatically, you can run the Barco Product
Installation Wizard manually by following these steps:
a) Click the Start button in the task bar.
b) Click Run.
c) Click Browse and browse to the root directory of the B
ARCO
N
IODisplay System Installation CD-ROM and click on the file,
Setup.exe, and click Open.
d) Click OK.
or
a) Browse to the root directory of the B
ARCO NIODisplay System
Installation CD-ROM and double click on the file, Setup.exe.
3. Click Next on the Welcome page.
4. Click Next on the Components to be installed page.
5. Follow the wizard’s on-screen instructions to complete the
installation.
Note: When the page shown in figure 25 appears you may
either click Next to accept the default settings or if you know the
settings required for your viewing application, you may select