Bartec Pro Series User Manual

Bartec USA TPMS PRO Series User Guide Rev5.1 Table of Contents
Page 23
3.5 Performing a TBYT (Continued – 2)
3. On the Operations screen, the tool will default to the Left Front wheel position and
prompt with Press Test to Activate Left Front. Position the tool accordingly (see
Section
2.3 for proper tool positioning) and press the Test key.
The tool will send the LF signal necessary to activate the sensors for the selected MMY and
listen for the correct UHF output from the sensor. Keep the tool in position until the
progress bar has completed and the tool indicates the results next to that tire position
(see Section 2.3.4
for possible responses).
4. Continue with the Right Front, Right
Rear, and Left Rear as the tool
prompts you.

Bartec Pro Series Specifications

General

Brand	Bartec
Model	Pro Series
Category	Diagnostic Equipment
Language	English