M.DRIVE.DB-21.GEN.ENG
Ed.
2021 Rev.04
Pag. 2 di 31
1 SAFETY AND INSTALLATION_____________________________________ 4
1.1 SAFETY CONSIDERATION AND INSTALLATION CONSTRAINS _________________________________ 4
1.2 EMC ADVICES ______________________________________________________________________ 4
1.2 SPECIFICATIONS ____________________________________________________________________ 5
2. ELECTRICAL CONNECTIONS ____________________________________ 6
3. DRIVE AND TURRET LAYOUT ____________________________________ 7
4. TURRET CONNECTIONS _______________________________________ 8
4.1 TB/TBH SERIES (STANDARD ELECTRICAL BOARD ON THE TURRET) __________________________ 8
4.2 TB/TBH SERIES (HARTING CONNECTOR) ________________________________________________ 9
4.3 TAB SERIES (STANDARD ELECTRICAL BOARD ON THE TURRET) _____________________________ 10
5. J1 INPUT/OUTPUT __________________________________________ 11
5.1 CONSENT TO WORK ________________________________________ 11
5.2 POSITION FEEDBACK _______________________________________________________________ 11
5.3 ALARMS _________________________________________________ 11
5.4 START COMMAND __________________________________________ 11
5.5 OPERATIVE MODE __________________________________________________________________ 12
5.6 POSITION REQUIRED _______________________________________________________________ 12
6. DIPSWITCH SETTING (FOR TURRET TYPE SELECTION) ________________ 13
7. WORKING LOGIC AND POSITIONING INQUIRY _______________________ 15
8. OPERATIVE MODE ___________________________________________ 16
9. DRIVE SET-UP (NEW TURRET INSTALLATION) ______________________ 17
10. DUTY CYCLE (BARUFFALDI LIVE TOOL TOOLING SYSTEM) ____________ 19
11. DUTY CYCLE (BMT/DIN5480/DIN1809 LIVE TOOL TOOLING SYSTEM) ____ 20
12. DRIVE ALARM _____________________________________________ 21
13. SERVICE _________________________________________________ 22
13.1 TROUBLESHOOTING _______________________________________________________________ 22
13.2 COMPATIBILITY WITH PREVUIOUS VERSIONS ___________________________________________ 25
13.2.1 drive and motor timeline _________________________________________________________________ 25
13.2.2 turret serial number identification _________________________________________________________ 25
13.3 DRIVE REPLACEMENT (SET-UP AND SETTING) __________________________________________ 26
13.3 MOTOR REPLACEMENT _____________________________________________________________ 29
13.4 RESOLVER ACQUISITION ___________________________________________________________ 29
13.5 ZERO SENSOR SETTING ____________________________________________________________ 30
13.6 CABLE ADAPTER FOR OLD DRIVE INTERFACING ________________________________________ 31
To Next Page
Loading...
