BAS-IP AK-10 - Intercom; Address Settings

Configuration through web interface– 63
Intercom
Address settings
Building:
Unit:
Floor:
Room:
Device number:The sequence number of the monitor in the system.
Sync code:Synchronization code between monitors and panels for an intercom.
MS IP address:The address of the PC or server where the monitoring software for the intercom
system is installed: Management Software or Link.
building number
0001-9999

Unit number
00-99

Floor number
00-99

Room number
01-99

If the monitor is one, it is necessary to set "0" in this line. If there are several monitors, then the
numbering should begin with "0" and end with "8".
