BASF 6106 - Operation

3.2.
OPERATION
3.2.1.
GENERAL
There are no
front panel
controls on the BASF
6106. All
power and control functions are
handled
through the
interface. Operating
procedures
consist primarily of loading and
unloading
the mini disk.
3.2.2.
MINI DISK
STORAGE AND HANDLING
The
following
are essential requirements
for
mini
disk
storage
and
handling:
The mini disk
should be stored
in
an
enviroment
that
is clean and free
from all magnetic influences.
The mini
disk
should be
in
same
tem-
perature and humidity
enviroment as
the disk drive for a
minimum of five
minutes prior
to
use.
Return mini disk to protective en-
velope
when
not in use.
Never place
heavy
objects
on the
mini disk cartridge.
Never touch
the
mini disk
trough the
cartridge
opening
when
handling.
Never attempt to clean the mini disk.
Do not bend or fold the mini disk.
Do
not
use rubber bands or paper
clips
on
the mini disk.
Never
write
on
cartridge (use labels).
Do not expose mini disk to excessive
heat
or sunlight.
LABEL
Caut ion
: insert fully before closing
the front
door
FIGURE
3-11.
MINI DISK LOADING
STEP ACTION
1
Press front
door to open position
2
Insert minidisk
fully with label
towards
front door
3
Close
front door
TABLE
3
-
11
. MINI
DISK
LOADING
Proper loading
of the
mini disk
is vital
to
the operation of
the mini disk and
drive.
Figure
3-11
shows
the proper loading
of the
mini
disk.
STEP
ACTION
1
Press
front
door
to open
position
2
Remove
mini disk
Procedures
for
loading and
unloading
the mini
disk
drive are
given
in Tables
3-
11
and
3-12
respectively.
TABLE
3
-
12
. MINI
DISK
UNLOADING
X
-.
11