Basler BIP2-XXXXc - 5 The Terminal Connector

AW00097209000 The Terminal Connector
Basler IP Fixed Box Cameras 83
5 The Terminal Connector
The 8-pin terminal connector on the back of the camera can be used to:
 provide power to the camera (when PoE is not used)
 access the camera’s I/O ports
 access the camera’s RS-485 connection
The terminal connector on the camera is a Weidmüller header (part number 1807480000).
The recommended mating connector is an 8-pin Weidmüller plug (part number 1727650000). A
Weidmüller plug of this type is shipped with each camera.
The pin numbering and pin assignments for the terminal connector are as illustrated below.
The pin assignments are described in more complete detail in Table 3 on page 85.
NOTICE
Do not apply AC voltages or voltages outside of the specifications to the camera.
1. Apply only DC voltages. Applying AC voltages can seriously damage the camera.
2. Make sure that the voltages are within the limits specified in Table 3 on page 85. Applying
voltages outside of the specifications can seriously damage the camera.
Fig. 9: Terminal Connector Pin Numbering
1
2
3
4
5
68
7
DC
Out
I/O-0 I/O-1
I/O-2
Gnd Alt.
Camera
Power
RS-485
A+
RS-485
B-