AW00097209000 Configuring the Camera
Basler IP Fixed Box Cameras 19
3.4 Streaming Parameters
The parameters in the Streaming group are used to control the characteristics of the image area that
will be captured by the camera’s sensor. They are also used to control the characteristics of the
video streams that are output from the camera.
The camera can produce up to three individually configured video streams. The streams are
designated as stream 0, stream 1, and stream 2. Stream 0 is always enabled. Streams 1 and 2 can
be either enabled or disabled. Each stream can be accessed by multiple network users.
For more information about video streams, see Section 3.1 on page 7.
When you open the Streaming parameters group, the camera enters the
"configuration" mode. When you close the Streaming parameters group, the
camera will return to "normal" mode and any parameter changes you made will be
applied.
When the Streaming parameters group is open, the images displayed on any
editor tabs in the web client will be refreshed approximately once per second.
To Next Page
Loading...
Need help?
General
