Basler DECS-250 - Page 174

21-6 9440300990
BESTlogic™Plus DECS-250
Name Description Symbol
LFSM Active
True when Limited Frequency Sensitive Mode
(LFSM) is active.
LFSM Enable
True when LFSM is enabled.
LFSM Normal
Operation
True when LFSM is enabled and grid frequency is
within the dead band.
LFSM Over
Frequency Active
True when LFSM is enabled and grid frequency is
greater than the LFSM-O Dead Band setting value.
LFSM Recovery
Active
True when LFSM is enabled and the Grid Recovery
timer is active.
LFSM Under
Frequency Active
True when LFSM is enabled and grid frequency is
less than the LFSM-U Dead Band setting value.
LVRT Active
True when Low Voltage Ride Through (LVRT)
mode is active.
LVRT AEM
Comm Fail
True when the LVRT Adjust Source setting is set to
an AEM Analog Input and the Remote Control
Failure Timer has expired.
LVRT Bridge
Active
True when LVRT Bridge mode is active.
LVRT Bridge
Enable
True when LVRT Bridge mode is enabled.
LVRT CANBus
Comm Fail
True when the LVRT Adjust Source setting is set to
CANBus and the Remote Control Failure Timer has
expired.
LVRT Enable
True when LVRT mode is enabled.
LVRT Modbus
Comm Fail
True when the LVRT Adjust Source setting is set to
Modbus and the Remote Control Failure Timer has
expired.
LVRT Remote
Comm Active
True when the Remote Control Failure Timer is
active. The Remote Control Failure Timer is always
active and resets frequently, during good
communications.
LVRT Remote
Comm Fail
True when the Remote Control Failure Timer has
expired for any communication protocol (defined by
the Adjust Source setting).
LVRT Remote
Failmode
True when LVRT remote communication has failed.
Internal Tracking
Active
True when internal tracking is running.
IRIG Sync Lost True when IRIG signal is not being received.
Manual Mode
Active
True when the unit is in Manual mode (FCR/FVR).