Page 14 For technical questions, please call 1-888-866-5797. 70813
SAFETY OPERATION MAINTENANCESETUP
5. Shielded Ball Bearings do not need
lubrication. Small amounts of lightweight
machine oil can be applied to belt tension
mechanisms and sliding surfaces.
6. Paste wax can be applied occasionally to Work
Table to keep it slick and corrosion free.
7. AFTER USE, disconnect from power source, clean
by brushing and wiping with clean, moist cloth.
8. If storing for a long period, release tension on the
Blade using the Blade Tensioning Release Lever.
Refer to, Saw Blade Tracking and Tensioning
on page 11. The blade’s tension and tracking
will need to be adjusted after thus storing.
9. WARNING! If the supply cord of this power
tool is damaged, it must be replaced only
by a qualified service technician.
10. Clear all saw dust from Dust Tube at base
of Band Saw. Do not let dust accumulate.
Occasionally, vacuum out entire Band Saw.
Record Product’s Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only, and are not available
individually as replacement parts. Specify UPC 193175514677 when ordering parts.
To Next Page
Loading...
