MV3−A/10/06
WARNING
Instruction Manual Junior II
5
2. SAFETY MEASURES
2.1. NOTES AND WARNING SIGNS
Notes and warning signs displayed on compressors accord
ing to model, application or equipment.
WARNING
Hot surfaces, do not touch!
Danger of burning by touching cylinders,
cylinder heads and pressure lines of individ
ual compressor stages.
WARNING
High voltage!
Life threatening danger of electric shock.
Maintenance work on electric units or op
erating equipment may only be carried out
by a qualified electrician or by a person
instructed and supervised by a qualified
electrician according to electrical regula
tions.
WARNING
Automatic compressor control, unit may
start-up without warning!
Before carrying out maintenance and repair
work, switch off at the main switch or dis
connect from the mains and ensure unit will
not restart.
MANDATORY
Instructions must be read by persons oper
ating the machinery!
The instruction manual supplied and all
other applicable instructions, regulations
etc. must be read and understood by oper
ating personnel before using the machine.
MANDATORY
Hearing protectors must be worn!
Hearing protectors must be worn when
working on a machine which is running.
NOTE
Ensure correct direction of rotation!
When switching on the machine, check the
arrow to ensure correct direction of rota
tion of the drive motor.
2.2. IDENTIFYING THE SAFETY NOTICES
Important instructions concerning the endangerment of per
sonnel, technical safety and operating safety will be specially
emphasized by placing the following signs before the instruc
tions.
This notice is used with maintenance
work and operating procedures and
must be adhered to exactly in order to
avoid endangering personnel.
This notice must be complied with in order to
avoid damage to or destruction of the machine
or its equipment.
This notice advises of technical requirements
which the operator must take particular note
of.
2.3. FUNDAMENTAL SAFETY NOTICES
2.3.1. Authorized use
• The machine / unit is built according to state of the art
technology and established safety technical regulations.
Nevertheless, its use can cause danger to life and limb of
the operator or third parties or damage to the machine
and other equipment.
• Operate the machine / unit only in technically perfect
condition in accordance with regulations and safety and
danger notices detailed in the instruction manual! In par
ticular, immediately correct faults (or have them cor
rected) which can impair safety!
• The machine / unit is exclusively for the compression of
mediums (air/gas) specified in section A, chapter 1.3.
“Technical data”. Any other medium or use outside that
specified is not authorized. The manufacturer / supplier is
not liable for damage resulting from this. The user alone
is responsible for this risk. Authorization for use is also
under the condition that the instruction manual is com
plied with and inspection and maintenance requirements
are enforced.
2.3.2. Organizational measures
• Keep the instruction manual to hand near the machine /
unit at all times in the relevant holder.
• In addition to the instruction manual, observe and com
ply with universally valid legal and other obligatory re
gulations regarding accident prevention and environ
ment protection. See chapter 2.4. This can involve, for
example, contact with hazardous substances or the provi
sion / wearing of personal protective equipment.
• Personnel engaged to operate the machine must have
read the instruction manual before beginning work, es
To Next Page
Loading...
