F1F1 F1 F2
F3 F4
9 Settings
9 Settings
9.1 Accessing the settings
To display/change the list of SERVICE settings, proceed as follows:
press the F3 key, the symbol on the menu bar starts to flash;
turn the knob until you reach the symbol to access user settings,
symbol to access installer settings, then
knob to enter code 0012
turn until you reach the
press the F4 key to confirm;
if accessing the installer menu, use the
and confirm by pressing the F4 key
turn the
knob until you reach the desired setting, then press the F4
key to confirm;
knob;modify the value of the setting using the
press F4 to confirm;
press F1 to exit.
Danger
FOR LOW TEMPERATURE HEATING INSTALLATIONS
MODIFY SETTING CP000 ACCORDING TO THE MAXIMUM
FLOW TEMPERATURE.
Important
The factory settings for certain settings may differ based on the
market the product is destined for.
Fig.60 Step 2
9.2 List of parameters
Tab.27 Table of parameters
Name Description
Factory
value
Minimum Maximum Level
F1F1 F1 F2
F3 F4
AP073
Average external temperature [°C] when switching
from summer/winter mode (with outside sensor)
22 10 30 User
AP079
Building insulation level (with outside sensor)
0: Poorly insulated building
15: Well insulated building
3 0 15 Installer
CP000 Max. settable heating setpoint temperature [°C] 80 25 80 Installer
CP020
Zone function
1: Enabled
0: Disabled 1 – – Installer
CP210
Comfort mode heating curve offset (with outside sen
sor)
15 15 90 Installer
CP230 Heating curve slope (with outside sensor) 1.5 0 4 Installer
CP470
Number of days required for the screed drying pro
gram
0 0 30 Installer
CP480 Screed drying starting temperature [°C] 20 20 50 Installer
CP490 Screed drying stop temperature [°C] 20 20 50 Installer
CP780
Zone control strategy selection
0: Automatic
1: Room Temp. based
2: Outdoor Temp. based
3: Outdoor & room based
0 – – Installer
56 600 Combi 2
To Next Page
Loading...
Need help?
General
