9 Settings
Tab.30 List of statuses
STATUS
Standby 0
Heat request 1
Burner ignition 2
Operation in heating mode 3
Operation in domestic water mode 4
Burner off 5
Pump post circulation 6
Burner shutdown to reach the temperature setpoint 8
Temporary fault 9
Permanent fault (fault to be reset manually) 10
Chimney sweep function at minimum output 11
Chimney sweep function at maximum output in heating mode 12
Chimney sweep function at maximum output in domestic water mode 13
Manual heat request 15
Frost protection function active 16
Venting function active 17
Boiler reset in progress 19
Tab.31 List of sub-statuses
SUB-STATUS
Standby 0
Wait time until next ignition in heating mode 1
Pre-ventilation 13
Burner ignition signal sent to safety core 15
Burner pre-ignition 17
Burner ignition 18
Flame check 19
Fan operation during ignition attempts 20
Operation at set temperature setpoint 30
Operation at limited temperature setpoint 31
Operation at required output 32
Level 1 gradient detected 33
Level 2 gradient detected 34
Level 3 gradient detected 35
Flame protection active 36
Stabilisation time 37
Boiler start at minimum output 38
Operation in heating mode has been interrupted by a domestic hot water request. Restart from power output in which
it was interrupted.
39
Post ventilation 41
Fan off 44
Output reduction due to high flue gas temperature 45
Pump post circulation 60
60 600 Combi 2
To Next Page
Loading...
Need help?
General
