7219620.01 (1-04/15) 40
INSTALLER Section (en)
16. ADJUSTMENT AND SAFETY DEVICES
Limit thermostat
circuit overheats.
NTC fumes sensor
heating.
Flame ionisation detector
these conditions, the boiler blocks.
Hydraulic pressure switch
Pump post-circulation
thermostat causes the main burner to go out.
Antifreeze device
Anti-block pump function
operate for 10 seconds.
Three-way valve anti-blockage function
Hydraulic safety valve (heating circuit)
heating circuit.
Heating pump pre-circulation
In case of a heat demand in the heating mode, the appliance can pre-circulate the pump before the burner is ignited. This pre-
17. PUMP CAPACITY/ HEAD
KEY TO PUMP CHARTS - "SECTION" E
Q WATER FLOW RATE MIN Minimum speed of modulation
H HEAD MAX Maximum speed of modulation