BBE BenthoTorch - Factory Settings and Correction Factor; Restoring Factory Settings

Operating the bbe BenthoTorch
bbe BenthoTorch Manual Page 32
SET FP DIAS
< high conc. >
OK <- -> ESC
11. Repeat with the other algae classes
12. When all calibrations are done, the all calibration parameter can be calculated at once:
Cal. Competed:
Calculate now?
YES NO
Internal Temperature
The internal temperature of the BenthoTorch can be shown.
S HOW INTERNAL TEMPERATURE :
Int.Temperature:
25.5 °C
OK
Shows the internal temperature.
Voltage
The voltage of the internal rechargeable battery can be shown and calibrated.
S HOW VOLTAGE :
Battery voltage:
6,35 V
OK
Shows the measured depth with the current calibration.
C ALIBRATE VOLTAGE :
Calibration of the voltage shall only done by the bbe service.
Factory settings
To reset the instrument to the factory settings including the factory calibration, please use this menu.