The Menus
bbe BenthoTorch Manual Page 58
6. Click “A
PPLY
” to store the changes in the new parameter set.
7. Click “R
ECALC
” to recalculate the data with the new parameters.
8. Recalculated data sets are marked in table view at the beginning of each line:
R
ESTORE DATA WITH ORIGINAL PARAMETERS
The original data of the measurement is not deleted by the recalculation. It is always possible to see the results
calculated with the parameters valid when the measurement was taken.
To restore the original data:
1. Select the instrument and time period (“W
INDOW
S
ELECT
D
ATA
”)
2. Go to “P
ARAMETERS
R
ECALC
”
3. Click “U
NDO
”. Please note: This item is only available when recalculated data are available in the selected
time period.
To Next Page
Loading...