BBE BenthoTorch - Position and Quality Settings

The GPS module
bbe BenthoTorch Manual Page 99
REQUIRED QUALITY
95%
OK + - ESC
95% is the standard quality value.
V ERSION (S ETTINGS -> GPS -> VERSION )
AXN-1.30 0145
Fasttrax IT500
OK
S TARTING THE MEASUREMENT
If the GPS module activated, the status of the GPS signal is shown after starting the measurement. If the given
quality criteria are met, the measurement starts automatically, otherwise, the poor positioning information can be
used (takepos) or the GPS information can be skipped.
PosFix Num Quali
YES 4 95%
takepos. skip
In case there is no GPS signal e.g. within buildings, only “skip” is available.
D ATA EVALUATION WITHIN THE T ORCH :
To view the measured data go to “Data -> View”:
The display shows the date and time of the latest result. Touch “more” as long as longitude / latitude can be
read:
54°20.3644`N
10°05.8699`E
more <- -> ESC
D ATA EVALUATION WITHIN BBE ++
After importing the data to bbe++ go to “Window -> New list window -> Default” to display results and position: