User Manual 11
Safety
Very important. As with any other appliance, do not touch the terminals of the mains, the
switch, or the power supply. There is a risk of electrocution. The other cables of the machine
operate at 24V and there is no risk whatsoever.
Connect the machine to an electrical outlet according to the current legislation.
Do not connect or disconnect any device and/or electrical connector when the machine is
connected to the power supply.
Keep all of your body and all objects away from the moving parts of the machine when they are
moving.
Do not touch the hot parts (heated bed and hot-ends) when the machine is switched on, and
wait 15 minutes after it has been switched off before touching them.
Handle the glass printing surface with care. Make sure it is not dropped or hit with anything as
this could seriously damage it.
The printing materials are not innocuous and emit toxic fumes. Always print in open or well-
ventilated spaces and use a protective mask.
Do not breathe closer than 25 cm from the extruder head when printing.
Supervise the printer while it is printing to make sure it is working properly.
In the event of emergency, stop the machine immediately by pressing the ON button, and
disconnect the power supply.
This device is not a toy. It should only be used by minors under 16 under the supervision of an
adult.
The spatula is a dangerous tool that can cause injuries. Use it only to remove plastic rests
when running the calibration assistant.
To Next Page
Loading...
