Maintenance Plan
We recommend you carry out the maintenance procedures described in the table below in order to keep your prin-
ter running optimally. The procedures are grouped depending on frequency they should be performed is shown on
the right.
Daily
ACTION TO PERFORMFREQUENCY
Weekly
Monthly
Quarterly
Keep the printer free of dust and in a dry, cool place
Storage the spools in a dry, cool place
Remove the filament inside the Purge Tank
Remove the filament leftovers spread inside the printer
Clean the Printing Surface
Clean the nozzles
Level the Printing Surface (also after a transportation)
Clean fans dust
Full calibration (also after a transportation or replacing a hotend)
Clean X/Y linear guides using a cloth
Clean Z bars using a cloth
Lubricate X/Y linear guides using sewing machine oil
Grease Z leadscrew using industrial multipurpose grease.
Check firmware updates
Check bolted and threaded joints
Check tension of extruder springs
Check X/Y belt tension
Check connections of moving cables
34 User Manual
To Next Page
Loading...
