EasyManua.ls Logo

Becker CentralControl CC41 - Dimensions; Intended Use

Becker CentralControl CC41
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Intended use
The control unit described in these instructions must only be used indoors for the oper-
ation of radio drives and radio control units that are compatible depending on the USB
radio stick.
An appropriate USB radio stick is also required for use in CentronicPlus, Centronic, B-
Tronic and other radio installations.
You can operate a group, or multiple groups, of devices with this controller.
Please note that radio-controlled systems may not be used in areas with a high risk
of interference (e.g. hospitals, airports).
The remote control is intended solely for use with equipment and systems in which
malfunctions in the transmitter or receiver would not pose any risk to persons, an-
imals or property, or which contain safety devices to eliminate such risks.
The operator is not protected from interference from other telecommunications
systems and terminal equipment (e.g. even from radio-controlled systems which
are properly operated in the same frequency range).
Only connect radio receivers to devices and systems approved by the manufac-
turer.
Ensure that the control unit is not installed or operated
close to metal surfaces or magnetic fields.
Radio-controlled systems transmitting on the same fre-
quency may cause reception interference.
Note that the range of the radio signal is limited by legis-
lation as well as by design.
Dimensions
All dimensions in mm.
115
115
25
18-en

Related product manuals