Commissioning
Real-time Ethernet port multiplier 47
Version: 2.6
Fig.63: Selection of the "Virtual Port" setting
Setting of the PROFINET Device or Controller adapter
Once the CU2508 has been activated as Multiple Protocol Handler in the system and the relevant ports have
been enabled, you can select an "Adapter Referent" under the "Adapter" tab for the Controller or the Device.
Enter the port through which you want to operate PROFINET.
Fig.64: Selecting the "Adapter Referent"
No other special considerations are required for the CU2508; you can proceed as usual.
To Next Page
Loading...