15
Miditherm MP
Starting a program with Finished time
• Switch on unit. The current temperature of the
furnace is displayed after approx. 3 seconds.
‚ Select program:
• Press as often until LED lights up.
• / drücken bis zur gewünschten
Programm-Nummer.
ƒ Call up Finished time:
Press (LED flashes).
„ Set weekday:
Press / .
1 = Monday, 2 = Tuesday, .... , 7 = Sunday
… Set time
Hours:
• Press (LED flashes).
• Press / for Finished time (hours)
Minutes:
• Press (LED flashes)
• Press / for Finished time (minutes)
† Exit Finished time mode:
Press once (LED lights up).
Notes
• Setting the current time and date: see the
“Settings” section.
• The furnace will start automatically so the
selected program is completed at the set
Finished time.
• Information on the time of the automatic start:
press .
• Delete a Finished time (LED lights up):
press .
• If the calculated and the actual Finished time
deviate significantly from each other (over 30
minutes), a correction program can be
started: when switching on the unit, keep the
button depressed (display shows P).
Attention: The correction program lasts approx.
8 hours!
‚
•
3 x
55
55
5
ƒ
To Next Page
Loading...