9
Miditherm MP
Basic principles
Explanation of the symbols
in these operating instructions
Press button
Lamp lights up
Lamp flashes
Displays after unit is switched on
0 .... 3 sec: parameter of the controller
> 3 sec: current furnace temperature
Furnace care
Prior to first use, start program #9 (see “Starting
a program” on page 14): The furnace heats up to
1050°C and maintains this temperature for 60
minutes. This results in the formation of a
protective oxide layer on the heating wire.
Always use the ceramic base.
Place the moulds in the chamber so there is no
contact to the walls as far as possible.
Software
To Next Page
Loading...